Front Suspension Arm for DRB/DIB, 1mm Aluminium Upgrade - YOKTS2142 Yokomo  [YOKTS2142]

Yokomo TS-2142 - Team Suzuki HG Aluminium Front Suspension Arm 1mm wide/Black for DRB/DIB
Price:
NZD$89.48
Brand:
Yokomo
Model:
YOKTS2142
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - DRB category
Write a review

Front suspension arm compatible with DRB and DIB

The Yokomo YOKTS2142 is an aluminium front suspension arm made for RC touring cars built on the DRB or DIB chassis. As an aftermarket replacement it provides a rigid mounting point for front suspension components and is supplied for hobbyist use only.

This part is a single-piece aluminium arm with a 1mm profile and black anodized surface. It installs into the front assembly to influence steering and roll characteristics; confirm fitment against your DRB or DIB front hub and mounting hardware prior to installation. Use this arm alongside existing suspension links to fine-tune toe and roll stiffness.

Fitting advice: inspect mounting pins and ball studs for any wear, make sure the arm orientation matches the hub carrier geometry, and tighten to the chassis maker's recommended torque. Apply threadlocker where metal-to-metal fasteners require it. This product is intended for 1/10 scale RC touring cars only.

Specifications

  • Item: Front suspension arm (RC scale)
  • Material: Aluminium
  • Model Number: YOKTS2142
  • Compatibility: DRB, DIB
  • Color: Black
  • Width: 1mm

Compatible Models

  • DRB
  • DIB

Select this aluminium arm when seeking a direct replacement to alter front-end response on DRB or DIB touring car chassis; pair with correct hardware and setup adjustments for best results.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

How robust is the aluminium construction?

Machined from aluminium and anodized, the arm offers improved rigidity over plastic replacements. It will show less flex under load but should be inspected after impacts.

Will the black finish scratch easily?

The black anodized coating provides a protective surface but can mark under strong impacts; routine checks will help identify any cosmetic or functional damage early.

Can I run this in wet conditions?

Anodizing helps resist corrosion, however prolonged exposure to water and dirt will require more frequent cleaning and maintenance to preserve fastener integrity.

How should I maintain the arm?

Keep mating surfaces clean, inspect for bends or cracks after heavy use, and replace the arm if any structural damage is found. Reapply threadlocker where specified during reassembly.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved