FT9 Rear Hub Plate +1mm Offset Compatible Part - Factory Pro O-SCP041  [FP-O-SCP041]

Aftermarket rear steering hub for FT9

This Factory Pro rear steering hub plate is an aftermarket hop-up designed for the Schumacher FT9 chassis and supplied as a pair. Constructed from graphite, the plate introduces a +1mm offset to adjust rear steering geometry without changing core suspension components.

Role and fit: the component replaces the OEM rear steering hub plate on FT9 cars to slightly move the steering link geometry. The modest +1mm offset helps refine rear traction and turn-in behaviour during setup sessions.

Fitting tips: remove the rear upright for access and swap the plates using your original fasteners where possible; confirm there is no binding across suspension travel. Recheck linkage geometry and servo endpoints after installation to maintain balanced steering travel.

Setup suggestion: use this adjustment for incremental changes, run short comparison sessions and pair the change with small tyre or toe tweaks for consistent handling results.