Futaba 1M11K51803 Top Housing for HPS-CT500 Servo Replacement  [FP-1M11K51803]

Price:
NZD$10.56
Brand:
Futaba
Model:
FP-1M11K51803
Condition:
Brand New
Write a review

Top housing suited to HPS-CT500

The Futaba 1M11K51803 top housing is intended for use with the Futaba HPS-CT500 servo as a direct swap for a worn or damaged upper shell. It protects the internals and keeps mounting points and control link interfaces in correct relation during normal operation.

Fitting is performed using basic servo service steps: remove the servo horn and screws, lift off the old top housing, transfer any seals or internal parts required, then refit the new housing in the original screw locations. Avoid forcing components and make sure gear alignment is correct before completing the reassembly.

For workshop maintenance this top housing provides a convenient way to refresh the servo exterior and perform quick component changes between sessions.

Is this top housing compatible with other Futaba servo models?

This part is produced to fit the HPS-CT500. It may not suit other Futaba models that use different dimensions or mounting layouts; always compare your servo's specifications before assuming compatibility.

Should I move seals and gaskets when replacing the housing?

Yes. If the original housing contains seals or internal fittings, transfer them carefully to the replacement to preserve environmental protection and correct spacing.

How does this part help during events or track days?

Keeping a spare top housing like this lets you perform fast repairs or swaps in the pits, reducing downtime and keeping your servo mounting and link geometry consistent.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved