6EXAP 6-Channel FM 40MHz/ R136F - Futaba  [6EXAP_c2]

CHARACTERISTICS:

• Aileron, Elevator and Rudder dual price switch - make use of this modification to flip between two aileron, elevator and rudder control throw settings. The tosses could possibly be setup but select, but broadly speaking, whenever switch is up the throws are greater (high rate) whenever switch is down the throws are less (low price). This switch additionally flips between exponential expenses (if used).
• Flap control dial/Channel 6 - This dial operates the servo linked to channel 6 towards the receiver as soon as your model has flaps here is the control accustomed run them.Aileron/elevator control stick -Mounting point for optional neck band.
• Trim levers (all) -Used to get the fundamental or center host to each servo as labeled in diagram.
• Recharging jack - Port for recharging the transmitter batteries along with the included electric batteries charger.
• On-off switch
• DATA INPUT lever - regularly exchange the values of the various functions presented in to the LCD screen.
• Liquid-crystal display (LCD) - shows development modes and values joined.
• MODE key - accustomed scroll through and show the ten or eleven(PCM) various functions.
• CHOOSE key - constantly show the values the existing function.
• Throttle-cut switch - to work with the throttle-cut function, lower the throttle stick entirely, then drive the throttle-cut change to entirely shut the carburetor and shut linked to the motor.
• Throttle/rudder control stick - runs the servos attached with channel 3 (throttle) and channel 4 (rudder) in receiver.
• Trainer switch - operates the trainer functions. To make use of as a trainer switch the transmitter must be attached with another transmitter via. a trainer cable (available on their own).
• Retractable landing gear switch/Channel 5 - modification operates the servo connected with channel 5 inside receiver if model has retractable landing gear this might be the control constantly expand and retract the apparatus.
• Antenna - Radiates signals on receiver. Don't ever travel a model without entirely expanding the antenna or simply you will produce interruption along with other modelers and decrease operational alert variety of the
• transmitter. The antenna might eliminated and replaced with another in case its inadvertently broken.

INCLUDES:

• Futaba 6-Channel 6EXAP transmitter
• Futaba R136F Receiver
• Change Harness
• Handbook

SPECS:

Transmitter

• T6EXAP Transmitter with programmable blending and 6-model memory.
• Transmitting on 40 / 72 MHz musical company.
• Operating-system: 2-stick, 6-channel system
• Modulation: FM(PPM) and PCM
• Power: 9.6V NT8S600B Ni-Cd battery power or 12V alkaline battery pack pack
• Present drain: 250mA

Receiver

• R136F slim musical company, FM 6 channel receiver.
• Receiving on 40 / 72 MHz musical organization.
• Type: FM, Dual conversion/FM, solitary conversion
• Intermediate frequencies: 455kHz, 10.7MHz/455kHz
• Power requirement: 4.8V or 6V
• Present drain: 9.5mA @ 4.8V
• Size: 1.31 x 1.98 x 0.71" (33.4 x 50.3 x 18.1mm)
• Weight 0.98oz (27.8g)