6EXAP 6-Channel FM 40MHz/ R156F - Futaba  [6EXAP_c3]

Price:
NZD$192.74
Brand:
Futaba
Model:
6EXAP_c3
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
R/C Models - System - Transmitter - Flight Transmitters category
Write a review
Futaba item 6EXAP - 6-Channel FM 40MHz/ R156F Flight Transmitters System

QUALITIES:
  • Aileron, Elevator and Rudder dual price switch - use this modification to flip between two aileron, elevator and rudder control throw settings. The tosses may be setup nevertheless select, but generally, after the switch is up the throws are greater (higher level) so when the switch is down the throws are less (low priced). This switch furthermore flips between exponential expenses (if utilized).
  • Flap control dial/Channel 6 - This dial runs the servo related to channel 6 to the receiver in case the model has flaps here is the control helpful to use them.Aileron/elevator control stick -Mounting point for optional throat strap.
  • Trim levers (all) -Used to go the fundamental or center host to every servo as labeled in the diagram.
  • Charging you jack - Port for recharging the transmitter batteries along with the included battery power charger.
  • On-off switch
  • INFORMATION INPUT lever - constantly change the values of assorted functions exhibited concerning the LCD screen.
  • Liquid-crystal display (LCD) - shows development modes and values joined.
  • MODE key - accustomed scroll through and show the ten or eleven(PCM) different functions.
  • PICK key - accustomed show the values the present function.
  • Throttle-cut key - to work well with the throttle-cut function, lower the throttle stick entirely, then drive the throttle-cut key to completely shut the carburetor and shut of motor.
  • Throttle/rudder control stick - operates the servos attached to channel 3 (throttle) and channel 4 (rudder) to the receiver.
  • Trainer switch - runs the trainer functions. To work well with as a trainer switch the transmitter must certanly be attached to another transmitter via. a trainer cable (available individually).
  • Retractable landing gear switch/Channel 5 - modification runs the servo attached with channel 5 in receiver should your model has retractable landing gear here is the control often increase and retract the gear.
  • Antenna - Radiates signals towards receiver. Don't ever travel a model without completely expanding the antenna or perhaps you may create disruption along with other modelers and decrease functional indication wide range of the transmitter. The antenna could possibly be eradicated and changed with another whenever it is inadvertently broken.

INCLUDES:
Futaba 6-Channel 6EXAP transmitter
Futaba R156F Receiver
change Harness
Handbook

SPECS:
Transmitter
T6EXAP Transmitter with programmable blending and 6-model memory.
Transmitting on 40 / 72 MHz musical company.
Operating-system: 2-stick, 6-channel system
Modulation: FM(PPM) and PCM
power: 9.6V NT8S600B Ni-Cd battery power or 12V alkaline battery
present drain: 250mA

Copyright © 2008-2024 rcjaz.co.nz All rights reserved