Futaba 6EXAP_c4 Pilot Radio 6-Channel PCM  [6EXAP_c4]

Price:
NZD$220.24
Brand:
Futaba
Model:
6EXAP_c4
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Control Features of the Futaba 6EXAP_c4

The Futaba 6EXAP_c4 serves RC flyers with a dependable 6-channel PCM setup tailored to both fixed wing and rotor models. Dual rate switching allows quick changes to aileron, elevator, and rudder throws, and the flap dial on channel 6 makes approach tuning straightforward.

Practical Features for Model Flying

  • Dual Rate Switch: Quickly reduce or restore control surface movement to match flying style and conditions.
  • Flap Control Dial: Smoothly operate flap servos from channel 6 to manage landing attitude and speed.
  • Programmable Mixing: Create mixes for different flight phases or model setups to simplify trimming.
  • LCD Screen: Easy menu navigation and clear readouts for setup values while at the bench.
  • Trainer Functionality: Plug in a trainer lead to practice with an instructor or hand over control easily.
  • Retractable Landing Gear Switch: Use channel 5 for retractable gear operation on suitable models.

Specifications

  • Operating System: 2-stick, 6-channel system
  • Modulation: FM(PPM) and PCM
  • Power Supply: 9.6V NT8S600B Ni-Cd battery or 12V alkaline battery
  • Current Drain: 250mA
  • Frequency Band: 40 / 72 MHz

Reliable and straightforward, the Futaba 6EXAP_c4 is a good fit for hobby pilots who want simple programming and dependable signal handling.

This unit pairs with receivers that match its frequency band and modulation. For older PCM systems, ensure your receiver supports PCM or FM(PPM) as listed in its specs.
Measure current draw with a suitable meter while the transmitter is powered on. The typical current is around 250mA, but accessories and backlight use can change that.
Start with small flap angles and increase until you reach the desired landing behaviour. Use the flap dial on channel 6 to fine tune without reprogramming mixes.
Trainer compatibility depends on the lead and the other transmitter's wiring and protocol. Use the correct trainer cord and confirm both units support the same trainer connection method.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved