6EXAP 6-Channel PCM 72Mhz/ R136HP/ 4xS3003 - Futaba [6EXAP_c9]

Price:

NZD$316.77

Brand:

Futaba

Model:

6EXAP_c9

Not Available

Please kindly input your name and email address, we will inform you once we have the restocking.

Or you may find similar product under the
R/C Models - System - Transmitter - Flight Transmitters category

Write a review

Description

Futaba item 6EXAP - 6-Channel PCM 72Mhz/ R136HP/ 4xS3003 Flight Transmitters System

QUALITIES:

Aileron, Elevator and Rudder twin cost switch - reap the benefits of this modification to ��flip�� between two aileron, elevator and rudder control throw settings. The tosses is setup you decide on, but generally speaking, whenever switch is ��up�� the throws are greater (��high rate��) proper the switch is ��down�� the throws are less (��low rate��). This switch furthermore flips between exponential rates (if used).
Flap control dial/Channel 6 - This dial runs the servo linked to channel 6 inside receiver whenever the model has flaps here is the control regularly work them.Aileron/elevator control stick -Mounting point for optional throat band.
Trim levers (all) -Used to go the essential or center host to each servo as labeled in the diagram.
Charging you jack - Port for asking the transmitter batteries using the included battery pack charger.
On-off switch
DATA INPUT lever - accustomed change the values of several functions shown in LCD display.
Liquid-crystal display (LCD) - shows programming modes and values joined up with up with.
MODE key - constantly scroll through and show the ten or eleven(PCM) different functions.
SELECT key - usually expose the values the current function.
Throttle-cut key - to work with the throttle-cut function, lower the throttle stick totally, then drive the throttle-cut key to totally shut the carburetor and shut the motor.
Throttle/rudder control stick - Operates the servos connected with channel 3 (throttle) and channel 4 (rudder) into the receiver.
Trainer switch - runs the trainer functions. To utilize as a trainer switch the transmitter must be linked to another transmitter via. a trainer cable (available individually).
Retractable landing gear switch/Channel 5 - Switch runs the servo associated with channel 5 in receiver if for example the model has retractable landing gear this is actually the control constantly expand and retract the gear.
Antenna - Radiates signals toward receiver. Do not ever travel a model without totally expanding the antenna or you may create disruption to varied other modelers and decrease operational indication choice of the transmitter. The antenna might removed and changed with another in the case its inadvertently broken.

Hot Brands

6EXAP 6-Channel PCM 72Mhz/ R136HP/ 4xS3003 - Futaba [6EXAP_c9]