Futaba 6EXAP_c7 6-Channel Flight Radio 35MHz PCM - Model 6EXAP_c7  [6EXAP_c7]

Key features of the Futaba 6EXAP

The Futaba 6EXAP delivers a six-channel controller intended as a plug-and-play radio for aeroplane and helicopter modelers. Its layout exposes the main flight surface controls and engine throttle, plus dedicated channels for flaps and retracts so you can complete field setup without added programming tools.

Channel routing is arranged as follows: channels 1, 2 and 4 for primary control surfaces; channel 3 dedicated to throttle; channel 5 for retractable landing gear operation; channel 6 for flap control when a flap servo is present. Physical toggles and knobs let the user change dual-rate settings, apply exponential curves, and engage a throttle-cut for ground safety.

• Controls: Dual-rate selection for aileron, elevator and rudder, flap adjustment knob for channel 6, individual stick trim levers, throttle-cut switch, trainer control and a gear switch on channel 5.
• Interface: Clear LCD with MODE and SELECT buttons, DATA INPUT lever for adjusting displayed parameters, charging socket and main power switch.
• Included electronics indicated in model name: The designation references the R136HP receiver and four S3003 servos as part of the package.
• Antenna practice: Extend the aerial fully before flight to secure maximum signal reach and reduce interference chances with other flyers.

This 6EXAP bundle provides a compact transmitter arrangement with distinct physical controls for dual rates, flap and gear management, helping simplify installation and in-field trimming while keeping the configuration transparent.