Futaba FU6A15501 Noise Filter Lead 50-Strand 220mm  [FU6A15501]

Extension lead to position a noise filter away from electronics

This Futaba FU6A15501 extension cord is made for RC use to move an in-line noise filter clear of confined electronics bays. The 50-strand heavy-duty conductor layout and 220mm length allow neat cable runs in tight model installations.

Function: by relocating the filter, the cable helps preserve clean signal paths between receiver, servos, and ESCs while keeping wiring runs organized. It is intended solely for typical radio-controlled model electrical systems and wiring tidying.

Installation guidance: avoid sharp bends and hot components, secure the lead at anchor points with ties or tape, and try to separate signal wiring from high-current power feeds. Verify connector compatibility with your filter and devices before completing the installation and recheck terminations for good contact.

If interference continues: inspect ground continuity, confirm each contact and crimp, test alternate routing away from motor and battery cables, and evaluate the filter location relative to the receiver and major noise sources.