Futaba FU6A16801 Battery Voltage Lead for CDR5000 Charger  [FU6A16801]

Voltage tap lead made for CDR5000 use

The Futaba FU6A16801 terminal harness cord is built to interface battery packs with a CDR5000 charger to enable voltage sensing. It provides a dedicated channel to carry pack voltage to the charger without the need to modify batteries or the charger casing.

This lead is intended specifically for the CDR5000 charger, so verify the charger model before installation. It works as a plug-in monitoring lead for charging, pack inspections and bench setups where a pack voltage display is required.

Fitting is simple: connect the harness to the charger’s sensing terminal and attach the correct battery connector to the pack’s voltage tap or the main terminals, depending on pack design. Protect contacts from dirt, ensure firm connections and avoid pulling on the cable to preserve connector life and reading accuracy.

For workshop and track-side maintenance the harness offers a convenient way to perform routine voltage checks, confirm cell balance numbers reported by the charger, and keep the sensing arrangement consistent when changing batteries on the bench.