Futaba FUAS3206 S3003 Servo Internal Metal Gear Set - EBS3206 AS3206  [FUAS3206]

FUTABA S3003 SERVO GEAR SET EBS3206 AS3206
Price:
NZD$6.48
Brand:
Futaba
Model:
FUAS3206
GTIN:
4513886301285
Condition:
Brand New
Write a review

S3003 gear set overview

This metal gear set is an aftermarket replacement for Futaba S3003 servos, supplying durable internal gears to replace worn plastic parts. The kit restores mechanical engagement inside the servo so hobbyists can fix backlash or stripped teeth without discarding the entire servo.

Installation notes: follow the documented S3003 case opening steps, lift out the existing gear stack and place the new gears in the identical sequence and orientation. Confirm gear mesh and endplay before sealing the case to avoid increased friction or binding during operation.

Tuning note: installing fresh metal gears improves positional repeatability and reduces slack that can affect control precision. After installation, center the output horn and bench test the servo across its full travel range prior to mounting it back in the model.

Will these gears mate correctly with the S3003 spline?

The kit is made to match the internal geometry of S3003 servos, including the spline interface used in that model, so it should mesh correctly when installed in an unmodified S3003 housing.

Should I lube the new gears and if so, what type?

A thin film of light synthetic grease on gear faces and bushings is recommended to reduce wear and noise. Avoid heavy greases that can slow servo response. Use a product suitable for plastic and metal gear sets.

How long can I expect the metal gears to last compared to the originals?

Lifespan depends on load and duty cycle, but metal gears generally offer improved wear resistance over standard plastic gears and will typically extend service life under similar operating conditions.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved