Futaba FUBS3285 Upper/Lower Shells Compatible with S9351 and S9155  [FUBS3285]

FUTABA S9351 S9155 UPPER/BOTTOM SERVO CASE SET BS3285
Price:
NZD$7.84
Brand:
Futaba
Model:
FUBS3285
GTIN:
4513886303388
Condition:
Brand New
Write a review

Service Replacement Shells for Futaba Servos

The Futaba FUBS3285 set supplies like-for-like upper and bottom shells created to fit Futaba S9351 and S9155 servos. These pieces are designed solely as mechanical enclosures and will not change the servo's electronics or internal gearing.

Do not assume interchangeability with other Futaba models or aftermarket servos; the fit is intended for the listed S9351 and S9155 units only. The shells protect the gear train, keep internal alignment, and permit straightforward swaps when performing maintenance.

Installation advice: remove the old case with appropriate tools, carefully move the PCB, gears, and output shaft into the replacement shells, check gear mesh and axial play, then secure the case and test servo movement using a transmitter or tester.

Do these shells need trimming or modification to fit?

In most cases the shells are form-fit for S9351 and S9155 and require no trimming. If you find a tight spot, inspect mounting posts and screw holes and only make minimal adjustments while monitoring alignment.

How should I transfer the PCB without damaging it?

Handle the PCB by its edges, avoid touching solder joints, and keep screws and small parts organised. Use the same screw sequence when reassembling to prevent stress on the board and connectors.

Are the mounting screws included or do I reuse the originals?

The listing does not guarantee new screws; plan to reuse the original fasteners where possible. If you must replace them, match thread and length to the original specifications to maintain secure mounting.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved