Futaba FUEBS3374 BLS154 Internal Gear Set AS4167 EBS3374  [FUEBS3374]

FUTABA BLS154 SERVO GEAR SET AS4167 EBS3374
Price:
NZD$12.95
Brand:
Futaba
Model:
FUEBS3374
GTIN:
4513886305184
Condition:
Brand New
Write a review

Internal gear kit for BLS154 servos

This Futaba FUEBS3374 kit serves as a service spare for BLS154-series servos, supplying the internal gears required when originals fail or show wear. It is intended to restore proper tooth engagement and reduce play in model steering or control assemblies.

Installation overview: remove the servo cover and document gear order and orientation, extract any stripped gears, move over bearings or bushings if needed, install the replacement gears in the original layout, then verify gear mesh and endplay before resealing the case. Use common small drivers and keep fasteners organised.

Tuning role: fresh gears return reliable feedback and centre response from the servo, assisting with accurate steering input and consistent behaviour during setup and fine tuning of scale models.

Notes and handling: avoid excess lubricant that can trap debris, confirm spline seating on the output shaft, and cycle the mechanism after assembly to ensure quiet, smooth operation.

How do I be sure this matches my BLS154 servo?

The gear set is made for BLS154-series servos. Cross-check part references such as AS4167 or EBS3374 from your servo to ensure you order the correct spare set.

Should I transfer bearings when replacing gears?

If your original bearings or bushings are serviceable, transfer them to the new gear stack. Inspect bearings for play or wear and replace if necessary to avoid premature failure.

Is there a recommended maintenance interval?

Maintenance frequency depends on use. For hobby running, inspect gears during routine checks or if you notice increased slop, noise or inconsistent centring; replace gears when wear becomes apparent.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved