Futaba FUSBS-01S SBUS2 Servo Telemetry Sensor for FASSTest and T-FHSS  [FUSBS-01S]

Telemetry Interface for Servos over SBUS2

This SBUS2 servo telemetry sensor from Futaba acts as an interface to transfer servo telemetry over SBUS2 to receivers that support FASSTest or T-FHSS. It links the servo output into the receiver's telemetry bus so the transmitter can receive immediate feedback for inspection and tuning.

The accessory is meant for occasions when knowing actual servo behavior speeds setup and trim work. Installation is simple for those familiar with Futaba equipment: insert the sensor into the receiver's SBUS2/telemetry-compatible port and follow your radio manual to enable telemetry channels.

Practical uses include verifying servo centring, end point changes and neutral stability during pre-run checks, improving confidence in adjustments before testing on track or in the air.

Fit this sensor when you need SBUS2 servo telemetry into a Futaba FASSTest or T-FHSS setup to streamline diagnostics and trimming on RC models.