Futaba FUSG29 Internal Gear Set for S29 and S129 Servos (W/O Packing)  [FUSG29]

FUTABA S29 S129 SERVO GEAR SET (W/O PACKING)
Price:
NZD$6.48
Brand:
Futaba
Model:
FUSG29
Condition:
Brand New
Write a review

Fit and Longevity Notes

This Futaba FUSG29 gear set serves as a component-level replacement for Futaba S29 and S129 servos, supplied without outer packing. It replaces degraded internal gears to recover smooth operation rather than acting as a complete unit.

Prior to fitting, inspect the existing gear teeth and bearings for uneven wear. Correct shaft seating and clean gear faces are important to avoid premature wear after installation.

For reassembly, preserve the original gear stack order, set the mesh carefully, and rotate the output to confirm free movement. Typical hobby hand tools are sufficient for the job.

How can I tell if the gears are worn?

Look for rounded teeth, excessive play in the output shaft, or grinding noises under load. These signs indicate the internal gears need replacement.

Will replacing the gears extend servo life?

Yes, fitting fresh gears can restore correct engagement and reduce stress on bearings and shafts, helping the servo run smoothly for longer when combined with proper inspection and lubrication.

Any upkeep tips after installation?

Keep the servo environment clean, avoid contaminant ingress, and periodically check mesh and bearing play to catch wear early.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved