Futaba S9070SB Digital S.Bus Servo - Tunable Performance  [S9070SB]

Futaba S9070SB - Digital S.Bus Programmable Servo
Price:
NZD$142.48
Brand:
Futaba
Model:
S9070SB
Condition:
Brand New
Write a review

S9070SB by Futaba - Tunable S.Bus Servo

The Futaba S9070SB digital S.Bus servo is built for hobbyists who need repeatable, low-friction control. With its dual ball bearings and compatibility with Futaba receivers made after 1982, it integrates cleanly into modern RC systems.

Setup, Programming and Use

This model can be configured using the SBC-1 Channel Setting Tool or PCLink software to fine-tune travel, centre and response profiles. It is suitable for retrofitting or new builds where adjustable servo behaviour is desired.

Specifications

  • Size: 35.9 x 19.5 x 24.9mm
  • Torque: 6.0V 76.4 oz-in (5.5 kg-cm), 7.4V 94.5 oz-in (6.8 kg-cm)
  • Speed: 6.0V 0.15 sec/60°, 7.4V 0.12 sec/60°
  • Mass: 32g

If you want a compact programmable servo that responds well to tuning and works with S.Bus, the Futaba S9070SB is a solid addition to an RC toolkit.

Can I run the S9070SB on a 2S LiPo setup?

Yes, the servo ratings include performance at 7.4V so it will operate on a 2S LiPo supply, but check your regulator and receiver power limits first.

Is programming required for basic use?

No. The S9070SB will work as a standard digital servo out of the box, but programming lets you tailor travel, centre and response for improved control.

How do I maintain the servo for long life?

Keep the case clean, avoid soaking it in water, and check linkages for play. If used in harsh conditions, regular inspection of the output shaft and bearings is recommended.

Can this servo be used for flaps and ailerons?

Yes, its speed and torque figures suit control surfaces on small to medium aircraft, especially when you need programmable endpoint and centering adjustments.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved