KYOSHO FW05-R/FW05RR Sway Bar Link End Pair FW05-008A by 3Racing  [FW05-008A]

Sway bar link ends for KYOSHO FW05 chassis

This pair of male and female link ends fits the KYOSHO FW05-R and FW05RR touring platforms, providing the connection between the anti-sway bar and the suspension linkage. They retain the factory fitment so you can replace worn pieces or experiment with different linkage lengths without fabricating adapters.

These components are intended for RC suspension tuning only and are not applicable to road vehicles. They are a simple way to adjust how roll inputs are transmitted to the wheels during corner entry and exit.

Installation guidance: lift the wheel as needed and loosen the linkage to access the sway bar ends, inspect bolts and pivot points for wear, then install the male and female ends to the correct locations. Rotate the suspension through travel by hand to verify there are no interference points before finally securing fasteners. Use threadlocker sparingly and only if the chassis guide calls for it.

Tuning tip: changing link end style or position alters load transfer and can help you dial out understeer or reduce excessive roll. Make measured changes and re-test on track to see the handling impact.