Kyosho FW05RR Compact Graphite Electronics Tray FW05-RR004 by 3Racing  [FW05-RR004]

Kyosho FW05RR Graphite Radio Tray - 3RACING FW05-RR004
Price:
NZD$39.29
Brand:
3Racing
Model:
FW05-RR004
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Lightweight graphite tray for FW05RR layouts

This graphite radio tray provides a rigid mounting surface for receiver and small electronics on Kyosho FW05RR chassis, while keeping additional mass low. Its stiffness helps keep chassis geometry consistent during tuning and quick setup sessions.

Intended as a drop-in replacement or upgrade, the tray centralises wiring and compact components to reduce cockpit clutter and make small balance adjustments easier. Clearer cable runs also simplify maintenance.

Fitment is straightforward when using the OEM radio bay points: align the tray, secure with the original mounting screws and route antenna and power leads away from moving linkages. Check servo and ESC positioning before final assembly to keep connectors accessible.

Specifications

  • Item: Radio tray
  • Material: Graphite
  • Model Number: FW05-RR004
  • Brand: 3Racing
  • Compatibility: Kyosho FW05RR

Tuners using Kyosho FW05RR will find the tray useful for cleaner wiring and easier component placement during setup and servicing.

Is this compatible with modified FW05RR chassis?

Compatibility depends on any aftermarket chassis changes; the tray matches stock radio bay dimensions so verify mount positions on modified frames.

How does graphite compare to plastic trays?

Graphite offers greater stiffness and lower weight than many plastics, delivering a firmer mounting platform with minimal added mass.

Any tips for neat cable routing?

Run power and signal cables along the tray edges, use small ties and keep antenna lead upright and clear of metal to avoid interference.

Will this plate shift chassis weight?

The tray itself is light; centralising small electronics can change local mass distribution slightly, so note any handling changes during setup.

Do I need to insulate the graphite surface?

If you mount bare electronics, use foam or double-sided tape to prevent shorting where components contact the graphite surface.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved