GB-01/GB-02 Reinforced Swing Shaft Tamiya GB-03/V2/LB by 3Racing  [GB-03/V2/LB]

Tamiya GB-01 Swing Shaft - Heavy Duty Ver. 2 - 3RACING GB-03/V2/LB
Price:
NZD$15.75
Brand:
3Racing
Model:
GB-03/V2/LB
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Durable swing shaft upgrade for GB-01/GB-02

This heavy duty replacement swing shaft fits Tamiya GB-01 and GB-02 chassis and carries the designation GB-03/V2/LB. It is offered as an aftermarket hop-up intended to address wear in the drivetrain of scale RC models.

Replace worn or bent shafts with this unit to reduce play under load and to keep wheel alignment consistent during hard cornering or regular club sessions. Heavy Duty Ver. 2 focuses on longevity and dependable fit rather than changing any suspension angles.

Installation tips: check existing bushings or bearings for correct sizing, verify axle alignment once installed, and confirm unobstructed wheel spin before pushing the model. Treat this as a drivetrain upgrade part for model use only.

Is this suitable for competition running?

It strengthens the drivetrain and can improve consistency, but always confirm fit and perform a brief run-in before race use.

Will I need new bearings?

Often the stock bearings will be fine; inspect for play and replace if there is excess wear to ensure correct fitment.

How do I check alignment after fitment?

With the model on stands, rotate the wheels and visually confirm axle straightness and even bearing seating; adjust as needed before running.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved