YZ-2 Front Bulkhead and Gearbox Support Z2-018M2A - Yokomo  [Z2-018M2A]

Yokomo Z2-018M2A Gear box support/Front bulk head mount for YZ-2
Price:
NZD$17.31
Brand:
Yokomo
Model:
Z2-018M2A
GTIN:
0639342216178
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - Off-Road Chassis Parts category
Write a review

Front bulkhead mount and gearbox support for YZ-2

The Z2-018M2A component functions as the gearbox support and front bulkhead mount that ships with the YZ-2DTMW lineup. Its reshaped profile is different from earlier versions and is intended to influence rear roll behavior on 1/10 on-road touring setups.

Used as an RC replacement part, it secures the gearbox and front bulkhead while serving as a tuning point. Changing the support geometry will alter how the rear end transfers load through the chassis in corners, helping to tune balance between front traction and rear rotation.

Fitment guidance: install this support in place of the factory unit on compatible YZ-2 variants; it mates to the existing front bulkhead mounting points and does not require any permanent changes to the main chassis. Assess handling with controlled test runs after installation.

Compatibility

  • B-YZ2DTMW
  • B-YZ2DTM2
  • B-YZ2CAL2
  • B-YZ2DTM2S
  • B-YZ2DTM3
  • B-YZ2CAL3
  • B-YZ2
  • B-YZ2CA
  • B-YZ2DT
  • B-YZ2DTM
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

What steps are involved to replace the factory support with Z2-018M2A?

Remove the original gearbox support, align the Z2-018M2A with the front bulkhead mounting points, and secure using the existing hardware. No chassis trimming or drilling should be necessary.

Will I need special tools to fit this part?

Standard RC hand tools are sufficient: basic drivers and pliers for removal and refit. Work methodically and keep fasteners organised to ensure correct reassembly.

How should I verify correct installation?

After installation, confirm all fasteners are tightened to the original locations and perform a few slow test laps to check for binding or unexpected handling changes before full-speed running.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved