This replacement kit provides stainless steel king pin screws for the Gmade 1/10 R1 Rock Buggy and Saw Back variants. It is intended as maintenance hardware to swap out worn pivot fasteners during routine servicing.
Included are 4 stainless screws sized 4.43x4.8XM3, selected to withstand exposure to water and grime from off-road use. These fasteners keep steering knuckle and suspension pivot fitment tight, preserving predictable chassis geometry after rebuilds.
Fitment guidance: these screws are made to directly replace the stock king pin fasteners on R1 and Saw Back layouts without needing chassis alteration. Recheck steering alignment and preload once fitted to ensure even handling.
Copyright © 2008-2026 rcjaz.co.nz All rights reserved
