GPH 346 GT Reinforced Cross Bar L=40 - HI0403268 by Hirobo  [HI0403268]

Lateral brace for GPH 346 GT frames

This RC-scale cross bar, sold as HI0403268, is made for GPH 346 GT assemblies and functions as a short lateral support that helps maintain chassis geometry and offers a dependable datum during build, inspection, and setup.

Purpose: maintain correct alignment between structural points, limit unwanted play at frame junctions, and serve as a fixed reference when adjusting linkages or replacing adjacent components. It is intended as a direct replacement where the original GPH 346 GT cross bar is used.

Fitting guidance: place the cross bar into the designated mounting locations without forcing parts, confirm frame alignment before final tightening, and re-check clearances after the first hover. Retain the original fastener specification and check for any looseness after initial flights.

Setup and maintenance advice: treat the cross bar as a bench reference when setting swash or blade geometry, watch for lateral movement that could influence cyclic response, and replace the component if wear appears at the contact points.