GPM BMT055 HPI Bullet 3.0 MT and ST Front Alloy Suspension Arm  [BMT055]

Replacement alloy front suspension arm for Bullet models

This alloy front suspension arm fits HPI Bullet 3.0 MT and ST chassis and serves as a direct replacement for the original front arm. It is intended for routine front-end repair, maintenance, or setup changes and is supplied as a 1pr set for hobby nitro buggy applications.

Installation requires straightforward RC tools such as hex drivers and common hardware; in most cases the existing mounting pins and ball studs can be reused unless they are damaged. The alloy build increases stiffness compared with plastic arms, which will influence steering feedback and suspension response, so make modest tuning adjustments after fitting.

Designed for hobbyists needing a more robust front arm, this alloy component suits the HPI Bullet 3.0 MT and ST. Use it when replacing broken parts or when dialing in front-end stiffness, and confirm compatibility with your steering linkage and mounting hardware.