Graphite Bumper Upper Plate for Tamiya TRF421X O-TCP013 by Factory Pro  [FP-O-TCP013]

Factory Pro FP-O-TCP013 Tamiya TRF421X - Bumper Upper Plate - Graphite
Price:
NZD$19.08
Brand:
Factory Pro
Model:
FP-O-TCP013
Condition:
Brand New
Write a review

Upper bumper brace for TRF421X chassis

The Factory Pro FP-O-TCP013 is an aftermarket graphite top plate built for the Tamiya TRF421X. It installs above the front bumper and uses the TRF421X stock mounting points as a direct replacement.

Graphite construction offers a stiffer local structure at the bumper mounts while remaining lightweight, which helps control chassis deformation under load and improves front-end consistency. The plate changes how impact energy and twist are transferred across the front section.

Fitment matches the TRF421X factory pattern and uses the original screw locations and hardware. During installation, position the plate carefully, tighten progressively to avoid over-stressing composite parts, and confirm there is no contact with the servo or suspension throughout full articulation.

In practice, moving to this stiffer graphite brace can reduce front-end chatter on high-grip surfaces and sharpen turn-in; adjust small amounts of caster and damper settings to find the best compromise.

Will the FP-O-TCP013 hold up to impacts and crashes?

Graphite provides stiffness but can be more brittle than metal; the FP-O-TCP013 improves local rigidity but should be inspected after hard impacts for hairline cracks or damage.

How should I look after the graphite plate?

Check mounting screws regularly for loosening, inspect the plate for any edge chipping after heavy use, and replace if any structural faults appear. Use the original hardware where possible.

Does graphite require special maintenance compared to plastic braces?

Not especially; graphite does not corrode, but you should avoid over-torquing screws and check for impact damage more often than you would with a flexible plastic brace.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved