Graphite Servo Ball Joint Set for 5.8mm Pivot Balls - XRAY 352670-G (4 pcs)  [XR-352670-G]

Tuning-Focused Graphite Link Ends

The XRAY 352670-G servo ball joint set is built as a lightweight, purpose-made linkage end for RC cars using 5.8mm pivot balls. The specially formulated graphite composite keeps mass low while delivering the stiffness needed for consistent steering response.

These joints permit smooth articulation on 5.8mm pivot balls and hold geometry under load to reduce slack in the steering assembly, which helps drivers dial in steering feel without adding significant weight. The low-friction graphite finish also resists mild contamination to preserve consistent movement.

To install, press each joint onto a 5.8mm pivot ball until it is fully seated, confirm unobstructed rotation and correct endplay, then fine-tune linkage positions as part of your steering setup routine. Periodically verify seating after tuning runs to keep feedback consistent.

Contents: set of 4 pcs graphite servo ball joints for 5.8mm pivot balls.