GT60 Intake Reed Block - OS28616000 for O.S. Engine  [OS28616000]

Intake reed for GT60 applications

This reed valve assembly serves as a replacement component tailored to the O.S. Engine GT60 family of two-stroke RC engines. It acts as the intake reed block within the glow-engine induction system on radio-controlled models, focusing on its intake duty.

Compatibility applies to units marked GT60 as shown in the product title; confirm your engine model before purchasing. The unit replaces the reed block area and is intended for hobby model engine use only.

Installation and tuning notes:

• Remove the carburetor and intake housing to reach the reed assembly, and adhere to the engine maker's disassembly procedure for safety.
• Ensure mating surfaces are flat and clean prior to fitting the new reed block to guarantee a proper seal and steady airflow.
• Refit using the correct gasket or an approved replacement to prevent intake leaks that degrade idle and throttle response.
• Tuning advice: reed wear alters throttle response and midrange power; monitor for flutter or sealing issues during bench runs and fine tune needle positions and carburetor balance as needed.

Maintenance tips:

• Inspect reed petals regularly for nicks or warping and replace if defects are present.
• Maintain correct hardware torque to avoid air ingress and preserve consistent engine performance.