GTX 2026 Rear Dogbone 98mm Hudy Spring Steel Upgrade - XRAY 355633-XH  [XR-355633-XH]

XRAY 355633-XH - Rear Central Dogbone Drive Shaft 98mm W 6 Degree h Pins - Hudy Spring Steel
Price:
NZD$73.07
Brand:
XRAY
Model:
XR-355633-XH
Condition:
Brand New
Write a review

Technical notes for the 98mm rear dogbone

This 98mm rear central dogbone is machined from Hudy Spring Steel and heat-treated to increase wear resistance. Material has been selectively removed to trim rotating mass while maintaining structural integrity through precise hand-finishing.

The assembly uses HUDY hardened pins in a 6° h-pin layout listed in the model designation to secure the dogbone under load. Each shaft receives CNC machining and individual inspection to uphold repeatable geometry for serious track use.

Installation notes: the dogbone is intended as a direct replacement for the rear central shaft in compatible GTX 2026 setups and couples with standard dogbone cups and diffs on 1/10 touring car drivetrains. Always verify pin fit and bearing alignment during installation and after initial running.

Specifications

  • Item: Rear central dogbone drive shaft
  • Material: Hudy Spring Steel
  • Model Number: 355633-XH
  • Compatibility: GTX 2026
  • Length: 98mm
  • Pins: HUDY hardened pins, 6° h configuration

When you need a hardened, low-mass central shaft for GTX 2026 rear drivetrains, the XRAY 355633-XH is a precision option that combines consistent geometry with track-ready durability.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

How can I tell if the shaft needs replacement after running?

Inspect for visible wear at pin contact points, scoring on the shaft surface, or increased play. If any of these appear, plan to replace the shaft to avoid driveline issues.

Does the CNC finish require any special inspection process?

Check the shaft for consistent diameter and surface finish along its length, and confirm pins seat flush. A run-in check for smooth rotation will reveal any alignment issues.

Are the HUDY hardened pins serviceable or replaceable?

The pins are hardened components; you can inspect and replace them if wear appears. Keep spares on hand and replace pins that show deformation or excessive wear.

Will hand-grinding affect shaft concentricity?

Hand-finishing is performed to tight tolerances to preserve concentricity. If you detect vibration or uneven rotation, re-check bearing alignment and shaft seating.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved