GTX Center Mount Carbon Rear Upper Brace - XRAY 354256  [XR-354256]

XRAY 354256 - GTX Carbon Center Mounting Rear Upper Brace - Flat Chassis
Price:
NZD$37.39
Brand:
XRAY
Model:
XR-354256
Condition:
Brand New
Write a review

Center-mounted carbon brace for GTX flat chassis

This compact carbon top deck joins the rear bulkhead to the center aluminum upper brace mount used on GTX flat chassis arrangements, serving as a focused structural link that affects rear flex and balance. Built for RC tuning work, the component increases local stiffness at the center without removing the overall chassis compliance needed for consistent grip across different surfaces.

Fitting the part is direct for those used to GTX series layouts: it secures at the center upper brace position and attaches to the rear bulkhead mounting points to create a direct load path. The brace is primarily a tuning item, letting drivers adjust rear-end character and transient response while keeping suspension geometry unchanged.

As an aftermarket carbon piece, the brace focuses on reliable mechanical response and straightforward serviceability. Periodic checks of screws and interfaces after running will help preserve consistent behaviour.

Specifications

  • Item: Rear center mounting upper brace
  • Material: Carbon fiber
  • Model Number: XRAY 354256
  • Compatibility: GTX 2026 flat chassis

This carbon center mounting rear upper brace is aimed at GTX flat chassis builds where tuned rear flex and repeatable handling are needed for setup adjustments.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

What tools do I need to fit the brace?

You will typically need common hand tools: an appropriate hex driver for the mounting screws, a low-torque driver for final tightening, and threadlocker if you use it on steel screws. Keep torque modest to avoid crushing the carbon layup.

Is any trimming or modification required?

No cutting should be necessary on properly manufactured GTX flat chassis. Check that the center upper brace mounting points align; if not, compare hole spacing before attempting installation.

Should I use threadlocker on the screws?

Using a medium-strength threadlocker on steel screws can help prevent loosening during hard use. Avoid over-application and ensure future serviceability when needed.

How do I verify correct fit after installation?

Once fitted, cycle the suspension through its travel and check for binding or contact with other parts. Tighten mounting screws to spec and re-check after a short test run.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved