Gyro Mount HI0404705 for Hirobo Eagle, Freya, EX and SX Helicopters  [HI0404705]

Purpose and fit of the gyro mount

The HI0404705 gyro mount is an RC-scale replacement made for Hirobo Eagle family airframes such as Freya, EX and SX. It provides the mounting interface for a tail gyro, helping maintain stable alignment between the gyro and the tail rotor linkage throughout setup and operation.

Installation focus: before final fastening check the mount orientation relative to the fuselage and tail boom, confirm there is enough clearance for control rods and wiring, and ensure fasteners are tightened to the proper torque to avoid loosening under vibration. Proper placement influences gyro feedback direction and may change servo load and trim settings.

Fit notes: intended as a direct-fit item for Eagle/Freya/EX/SX models, this mount typically uses existing holes and bosses on compatible frames. When swapping parts, compare mounting patterns and consider spacers if hole alignment differs, and centre the gyro before replacing the canopy.