HB TCXX 2.25mm Tuning Chassis - Arrowmax AM-TCXX-68483-V2  [AM-TCXX-68483-V2]

Arrowmax AM-TCXX-68483-V2 Main Chassis (2.25mm) V2
Price:
NZD$93.28
Brand:
Arrowmax
Model:
AM-TCXX-68483-V2
Condition:
Brand New
Write a review

Overview for HB TCXX Chassis Upgrade

The Arrowmax AM-TCXX-68483-V2 is an aftermarket main chassis plate designed for the HB TCXX platform, cut to 2.25mm and supplied as a direct replacement to the factory TCXX plate. It is a purpose-built accessory for 1/10 electric touring cars intended to tweak chassis flex and balance during setup work.

As a simple tuning change, swapping to this plate can modify overall stiffness, alter traction distribution between front and rear, and change how the suspension responds over different surfaces. The plate installs using the TCXX mounting layout, so basic removal of the stock plate and reuse of compatible hardware is expected.

Specifications

  • Item: Arrowmax AM-TCXX-68483-V2 Main Chassis (2.25mm) V2
  • Material: Not specified
  • Model Number: AM-TCXX-68483-V2
  • Compatibility: Hot Bodies TCXX

Tuners using the HB TCXX platform can use this V2 plate to fine-tune flex characteristics and handling balance, but always check fit and alignment with your particular kit revision before final fitting.

Can the AM-TCXX-68483-V2 be used on both carpet and asphalt tracks?

Yes, the plate can be trialled on different surfaces; because it changes chassis stiffness, you may need to adjust damping and spring rates to suit carpet or asphalt conditions.

Will this chassis affect my car's tendency to understeer?

Altering chassis flex can shift load transfer and steering response; an increase in stiffness may reduce chassis roll and can either reduce or increase understeer depending on the rest of your setup.

Is any trimming required during installation?

The plate is intended to use TCXX mounting points, so trimming is not expected for standard kits, but always dry-fit and check clearances around electronics and servo mounts first.

How should I inspect the new plate before running?

Verify hole alignment, screw engagement, and any potential contact with driveline or battery trays; replace any damaged hardware and perform a basic range and function test before track use.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved