HB TCXX Let Down Front Shock Tower - Setup Option Arrowmax AM-TCXX-68763-V2  [AM-TCXX-68763-V2]

Arrowmax AM-TCXX-68763-V2 Front Shock Tower (Let Down)
Price:
NZD$21.79
Brand:
Arrowmax
Model:
AM-TCXX-68763-V2
Condition:
Brand New
Write a review

Let Down front tower for TCXX

This front shock tower is an aftermarket option produced for HB TCXX chassis and offered by Arrowmax as model AM-TCXX-68763-V2. The Let Down configuration relocates the shock mounting point lower on the tower to change leverage ratios and roll characteristics without swapping the shock units.

Fitment and role: intended for HB TCXX-compatible front suspension assemblies, the part shifts shock angle and front-end behaviour to aid setup tuning. It is an aftermarket suspension component and mounts into the existing tower slots on the TCXX chassis.

Installation notes: remove the factory tower and carry over any compatible hardware, seals, and bushings, then secure the replacement at the stock mounting points. After fitting recheck ride height and piston positions, and perform gradual test runs to dial in changes safely.

Is this an original HB part or an aftermarket upgrade?

This is an aftermarket upgrade produced by Arrowmax and sold as AM-TCXX-68763-V2 for use on HB TCXX front assemblies. It is not a factory HB part.

How does the lower mount change front grip?

By lowering the mount the leverage and roll centre shift, which can increase initial turn-in or change mid-corner balance depending on other setup choices. Trial changes are recommended.

Any setup tips after fitting this tower?

Start with small piston or oil changes and recheck ride height. Note how front roll and steering response change, then adjust swaybars or rear settings to rebalance if needed.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved