Helicopter Linkage Rod End Pin HI2524003 2 x 45 10pcs for RC Link Repairs Hirobo  [HI2524003]

RC helicopter linkage rod end pin — HI2524003

This component is an RC-scale rod end pin identified by Hirobo model HI2524003 and comes in a pack of 10. It is intended for use in common helicopter linkage setups where short replacement pins are used to secure ball links or miniature clevises.

Replace worn pins with these when adjusting control throws or preparing a small spares kit for field troubleshooting. The label "2 x 45" is a size reference from the product name, so check dimensional compatibility with your linkage and retaining system prior to fitting.

To install: remove the existing retaining clip or fastener, withdraw the aged pin from the linkage or ball link, insert the new HI2524003 pin into place, and refit the original clip or retainer. After rebuilding, confirm there is free articulation and no binding throughout the full range of travel.

During setup these pins act as simple mechanical connectors rather than fine adjustment elements; they are useful for repeatable geometry when changing setups and for keeping spares during practice sessions.