HIROBO 0414-132 FREYA Elevator Lever Shaft L  [HI0414132]

Left-side elevator shaft description

This is a replacement RC-scale elevator lever shaft for the left side, supplied under the Hirobo model HI0414132 designation. The part is identified by the FREYA name and serves as a direct spare for the elevator linkage on FREYA series helicopters where left-side shaft replacement is required.

The component restores the mechanical link between the elevator lever and the tail control assembly. If a shaft exhibits wear or excessive play, installing this left-side replacement helps bring back predictable tail movement for both bench adjustments and flight trials.

Fitting follows typical tail linkage procedures: open the tail housing or remove the access panel, loosen and remove the retaining fasteners, transfer or replace shims as required, fit the new shaft in the correct orientation, then reassemble and confirm smooth operation before flying. Standard RC hex drivers and small hand tools are suitable for the job.