Hirobo HI0304107 Replacement Sleeve for EMBLA SZM2 Damper #65 Black  [HI0304107]

EMBLA SZM2 Damping Sleeve Overview

This damper rubber is supplied as a direct-fit sleeve for EMBLA SZM2 models to restore damping where the original material has stiffened or deteriorated. It targets rotor and tail damping points needing predictable rebound and control feel.

Install the sleeve without modifying the existing geometry; verify the rubber is fully seated over the damper post and keep mating areas clean of grit and excess lubricant that could affect movement. The part is identified by the #65 hardness mark and comes in black for a discreet match to the assembly.

Performance note: the #65 compound provides passive damping that will influence both feel and rebound in rotor and tail damping assemblies. Consider swapping hardness codes if you require different damping behaviour during tuning sessions.