Hirobo HI0304111 EMBLA SZM2 Replacement Yoke  [HI0304111]

HIROBO 0304-111 EMBLA SZM2 YOKE #0304111
Price:
NZD$34.89
Brand:
Hirobo
Model:
HI0304111
GTIN:
4512895156404
Condition:
Brand New
Write a review

Brief on EMBLA SZM2 cyclic yoke

This replacement yoke is intended for the EMBLA SZM2 scale helicopter and acts as the mechanical link between swashplate outputs and rotor pitch control, so it impacts cyclic characteristics and control precision.

The focus here is on fitment and setup rather than composition details. Installers should confirm alignment and secure all attachment points to retain consistent cyclic geometry. After swapping the yoke, re-check trim and endpoints to restore neutral pitch and equalized throws.

Use this part when reinstating factory-style fit on an EMBLA SZM2 or when replacing a damaged linkage component. It is described as a model accessory only.

Specifications

  • Item Yoke
  • Material Not specified
  • Model Number HI0304111
  • Compatibility EMBLA SZM2

Compatibility

  • EMBLA SZM2

Select this yoke for correct fit on EMBLA SZM2 helicopters and perform careful linkage checks and cyclic centering during the final setup phase.

Material is not specified in the description. Inspect the component on receipt for any visible defects and monitor for play or deformation during routine maintenance intervals.
Replacement frequency depends on flight hours and operating conditions; check for looseness, cracks, or wear at pivot points and replace the yoke if any symptoms appear.
Since material details are not provided, avoid prolonged exposure to moisture and inspect for corrosion if used near salt air. Replace at the first sign of compromised integrity.
After a hard landing examine the yoke for bending, check attachment points and link ball sockets for looseness, and verify cyclic centering before the next flight.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved