Hirobo HI0304112 Seesaw Linkage for EMBLA SZM2  [HI0304112]

HIROBO 0304-112 EMBLA SZM2 SEESAW #0304112
Price:
NZD$30.77
Brand:
Hirobo
Model:
HI0304112
GTIN:
4512895156411
Condition:
Brand New
Write a review

Seesaw Component Compatible with EMBLA SZM2

This Hirobo seesaw carries model number HI0304112 and is offered as a direct replacement linkage item for EMBLA SZM2 RC helicopters. The focus here is on fitment, installation guidance, and the seesaw's influence on control input geometry rather than on unspecified metrics.

Use the part when renewing linkage hardware or restoring correct control geometry during maintenance. The seesaw sits in the rotor control train and will affect cyclic and tail response depending on linkage lengths; check control throws and neutral positions after installation.

Specifications

  • Item: Seesaw linkage part
  • Material: Not specified
  • Model Number: HI0304112
  • Compatibility: EMBLA SZM2

Before flight, ensure the HI0304112 part matches the required service code for EMBLA SZM2 and reverify servo centring and endpoint settings following reassembly.

Will a new seesaw extend the service life of my linkage?

Replacing worn components with HI0304112 restores proper fit and geometry; overall longevity depends on flying conditions and maintenance habits, so inspect linkages regularly.

How do I spot wear on this part?

Look for play at pivots, hairline cracks, or deformation and check that connecting bearings move smoothly; replace the seesaw if any looseness or damage is detected.

Does the seesaw affect rotor balance?

The seesaw is part of the control train rather than rotor mass, so it usually does not change rotor balance, but uneven linkage wear can affect control symmetry and should be corrected.

Any tips to improve durability when fitting?

Ensure mating surfaces are clean, use correct torque, avoid over-tightening, and apply thread locking where appropriate to reduce premature wear.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved