Hirobo HI0404553 Root End for Eagle/Freya/EX/SX Helicopter Tail Linkages  [HI0404553]

HIROBO 0404-553 ROOT END #0404553
Price:
NZD$10.78
Brand:
Hirobo
Model:
HI0404553
GTIN:
4512895108274
Condition:
Brand New
Write a review

Role and application

The Hirobo root end bearing part number HI0404553 serves as a replacement terminal on the tail linkage assemblies of Eagle, Freya, EX and SX helicopters. It provides a compact joint point meant for routine service and quick swap-outs during maintenance.

Fitment is recorded across Eagle/Freya/EX/SX model lines; confirm the part code on your specific airframe before placing an order. The item is supplied as a single replacement piece to recover correct linkage geometry when an original component shows wear or slack.

Installation notes: detach the worn root end, inspect the adjoining pushrods and bearings for signs of wear, fit the new unit ensuring correct orientation and free articulation, then verify tail response at low throttle and adjust trims as needed to restore neutral alignment.

Which airframes commonly use HI0404553?

This part is listed for Eagle, Freya, EX and SX helicopters. Cross-reference the HI0404553 code with your model's parts list to confirm it matches your airframe's requirement.

Are any special tools required to install the root end?

No specialised tools are typically required beyond standard small RC hand tools. Ensure fasteners are secure and that the linkage moves freely after installation.

Will replacing this part affect tail tracking?

Replacing a worn root end can restore correct geometry and improve tail centring. After fitting, check tail tracking at low throttle and perform trim adjustments to re-establish precise control response.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved