Hirobo HI0404605 SSR-4 YORK Side Plate for Eagle/Freya/EX/SX  [HI0404605]

Overview of the SSR-4 York side plate

This Hirobo 0404-605 SSR-4 YORK SIDE PLATE #0404605 serves as a direct replacement component for SSR-4 York-configured RC helicopters. It is intended to provide the same structural support and mounting points found on airframes that use the shared parts set for Eagle, Freya, EX and SX models.

The unit is supplied singularly for model aircraft use only. Installation generally requires removal of the existing panel, alignment of the side plate to the frame mounting bosses, and securing with the original fasteners. Always cross-check screw lengths and thread types against your model documentation to prevent interference with nearby mechanisms.

For setup and tuning, the replacement plate preserves the original mount locations so servo brackets and control linkages retain factory geometry. Conduct inspections after the initial flights to confirm secure fastening and to check for any unexpected contact before returning to full-power operations.

Use this replacement if your helicopter uses the SSR-4 York layout with the common parts for Eagle, Freya, EX and SX; verify fit and perform routine checks after fitment.