Hirobo HI0404627 I-Type Lever A for Eagle/Freya/EX/SX Linkage Replacement  [HI0404627]

HIROBO 0404-627 EAGLE I-TYPE LEVER A #0404627
Price:
NZD$25.44
Brand:
Hirobo
Model:
HI0404627
GTIN:
4512895108687
Condition:
Brand New
Write a review

Service Replacement I-Type Lever

The Hirobo HI0404627 I-Type Lever A serves as a precision replacement part for the Eagle series and related models. It is designed to substitute a worn I-Type lever to recover consistent link behaviour in the rotor controls.

To fit the lever, remove the failed component from its ball joint or linkage arm, position the HI0404627 in the same orientation, and refit the original fasteners. Work the servos through their full range at low throttle to spot any binding and confirm free travel before attempting flight operations.

Small misalignment or wear at the lever can introduce control play or uneven response. After replacement ensure the ball link is properly seated, check end-to-end travel on the control rod, and adjust servo endpoints so neutral position and throws remain balanced.

How should I orient the HI0404627 when fitting it?

Install the lever in the same physical orientation as the removed unit, lining up the ball-seat and linkage arm. Correct orientation preserves travel geometry and reduces the need for endpoint changes.

Are specific torque settings required for the mounting screws?

Use the original torque recommendations from your build notes. Tighten to a firm, secure feel without over-torquing to avoid deforming the lever or damaging threads.

What actions remove binding after installation?

If binding appears, loosen the fasteners, re-seat the ball link, verify linkage straightness, and cycle the servo slowly while observing travel until motion is free.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved