Hirobo HI0414228 SSZ-II Mixing Arm for Eagle Freya  [HI0414228]

HIROBO 0414-228 SSZ -II MIXING ARM #0414228
Price:
NZD$35.79
Brand:
Hirobo
Model:
HI0414228
GTIN:
4512895129682
Condition:
Brand New
Write a review

Replacement mixing arm for Eagle Freya helicopters

The HI0414228 SSZ-II mixing arm by Hirobo serves as an aftermarket replacement for the Eagle Freya series. It transfers commanded swashplate motion into the rotor head mixing arrangement to maintain accurate linkage movement under load and during tuning.

As a direct replacement assembly, this mixing arm helps preserve the intended servo-to-rotor kinematics when you change swashplate throws or other head components. During fitment, make sure ball studs are fully engaged and that no link binding occurs at full travel.

Specifications

  • Item: SSZ-II Mixing Arm
  • Material: Manufacturer unspecified
  • Model Number: HI0414228
  • Compatibility: Eagle Freya series (Hirobo helicopter parts)

Fit this mixing arm to restore correct linkage geometry on Eagle Freya helicopters and confirm smooth operation through the swashplate sweep after installation.

Is the HI0414228 suitable for all Eagle Freya variants?

HI0414228 is listed for the Eagle Freya range; double-check your parts diagram to ensure compatibility with your specific variant.

Which points should I lubricate or inspect?

Keep ball joints and linkage pivots clean and lightly lubricated where appropriate, and verify there is no side play at the mounting points.

Does replacing it require trimming settings?

After swapping the mixing arm, check swashplate centering and re-trim endpoints if necessary to restore correct cyclic and collective behavior.

How should I verify a correct fit?

Fit the arm and move servos through full deflection while observing for binding; also confirm ball studs are properly seated and secure.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved