Hirobo HI0414375 EX2 Elevator Lever Replacement  [HI0414375]

Product summary for EX2 elevators

This elevator lever is intended as a direct service replacement for the EX2 elevator linkage on Hirobo radio-controlled helicopters. It performs the mechanical function of converting servo rotation into elevator movement and is suited to routine maintenance and setup work.

The focus here is on practical fit and adjustment rather than promotional claims. Replace a damaged or fatigued lever with this unit to restore reliable elevator feedback. During refit, pay attention to linkage geometry, servo arm alignment, and neutral trim to preserve stable hovering and accurate pitch responses.

Fitting is appropriate for modellers experienced with small-scale helicopters: remove the original lever from the rotor head, transfer over any reusable bearings or screws if serviceable, install the replacement, and confirm unobstructed travel and correct centring before flying. Fine-tune clevis location and servo endpoints to match original travel and avoid binding through the collective and cyclic ranges.

Use this replacement lever as part of normal airframe upkeep to maintain consistent elevator behaviour.