Hirobo HI2511003 M3 x 26 Replacement Cross Link for Helicopter Frames  [HI2511003]

Replacement linkage bar M3 x 26

The Hirobo HI2511003 cross member serves as an RC replacement part for general helicopter frames and assembly mounts. The M3 x 26 size identifies the screw thread and length interface compatible with common M3 fasteners used in many rotorcraft layouts.

Use this linkage when a fixed cross member is required to preserve alignment between mounting points or to secure small linkages. It is a simple structural item that supports consistent geometry important for predictable control response.

Installation advice: line up the cross member with the frame holes, fit appropriate M3 fasteners and confirm sufficient thread engagement for the material, and do not over-tighten to avoid thread damage in softer components. Remember that the component is passive and not intended to move under load.