Hobbywing 30408005 JUSTOCK Sensored 1/10 Motor Kit  [HW-30408005]

HOBBYWING JUSTOCK-3650SD-13.5T G2 - 30408005
Price:
NZD$0.00
Brand:
Hobbywing
Model:
HW-30408005
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review
alt="HOBBYWING JUSTOCK-3650SD-13.5T G2 - 30408005" title="HOBBYWING JUSTOCK-3650SD-13.5T G2 - 30408005"
alt="HOBBYWING JUSTOCK-3650SD-13.5T G2 - 30408005" title="HOBBYWING JUSTOCK-3650SD-13.5T G2 - 30408005"
alt="HOBBYWING JUSTOCK-3650SD-13.5T G2 - 30408005" title="HOBBYWING JUSTOCK-3650SD-13.5T G2 - 30408005"
alt="HOBBYWING JUSTOCK-3650SD-13.5T G2 - 30408005" title="HOBBYWING JUSTOCK-3650SD-13.5T G2 - 30408005"

Race-focused Sensored Motor for 1/10 Scale

The Hobbywing JUSTOCK-3650SD-13.5T G2, model number 30408005, is a sensored brushless unit built for 1/10 scale competition. Fixed timing and a 2800KV spec provide consistent output, and the motor accepts 2-3S LiPo packs for flexible performance tuning.

Tuned Size for Tight Chassis Layouts

The motor packs a 35.9mm outer diameter and a 52.5mm body length into a compact package. With a 3.17mm shaft and a 183g mass, it balances strength and weight to support sharp cornering and responsive handling on technical tracks.

Reliable Efficiency and Precise Response

Featuring a low no-load current of 1.9A, the motor keeps wasted draw to a minimum while the sensored rotor position sensing yields smoother throttle transitions and improved low-speed driveability.

Specifications

  • Scale: 1/10
  • Motor Type: Brushless
  • Sensor Type: Sensored
  • Pole Count: 2
  • KV: 2800
  • Battery: 2-3S LiPo
  • No-load Current: 1.9A
  • Diameter: 35.9mm
  • Length: 52.5mm
  • Shaft: 3.17mm
  • Mass: 183g
  • Timing: Fixed

For drivers who prize repeatable power and smooth control, the Hobbywing JUSTOCK-3650SD-13.5T G2 with model number 30408005 is a dependable fit for 1/10 race cars.

Inspect bearings after every few race weekends or when you notice increased noise or heat. Clean and re-lube where appropriate or replace if rough.
Standard 3-wire motor leads are used. Keep solder joints secure and use quality connectors on the ESC side to ensure reliable current transfer.
Begin with conservative pinion sizing to protect the motor and ESC, then increase pinion teeth gradually while monitoring temps and amp draw to find the sweet spot.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved