HOBBYWING QuicRun 3650SD 6.5T G2 Brushless Motor 30404312 - Precision Control  [HW-30404312]

HOBBYWING QuicRun-3650SD-6.5T G2 - 30404312
Price:
NZD$97.66
Brand:
Hobbywing
Model:
HW-30404312
Condition:
Brand New
Write a review
alt="HOBBYWING QuicRun-3650SD-6.5T G2 - 30404312" title="HOBBYWING QuicRun-3650SD-6.5T G2 - 30404312"
alt="HOBBYWING QuicRun-3650SD-6.5T G2 - 30404312" title="HOBBYWING QuicRun-3650SD-6.5T G2 - 30404312"
alt="HOBBYWING QuicRun-3650SD-6.5T G2 - 30404312" title="HOBBYWING QuicRun-3650SD-6.5T G2 - 30404312"
alt="HOBBYWING QuicRun-3650SD-6.5T G2 - 30404312" title="HOBBYWING QuicRun-3650SD-6.5T G2 - 30404312"

Core Control Unit: 30404312 Sensored Motor

The 30404312 sensored motor brings a steady mix of control and performance to 1/10 scale cars. Built for consistent throttle response, this brushless motor helps drivers keep lap times tight and driving smooth whether you are tuning for grip or sliding out on purpose.

Why Sensored Setup Helps

Sensored motors like this one deliver finer low-speed modulation and less cogging, which improves starts and slow-speed maneuvers. That makes them fitting for drift rigs, tight touring layouts, and classes where smooth inputs matter more than raw top speed.

Balanced Performance Specs

With a 5750 KV rating the 30404312 provides a lively feel on 2S LiPo batteries while remaining efficient for longer runs. Fixed timing removes a layer of setup complexity, and the compact 36mm by 52.8mm form factor fits most 1/10 and 1/12 chassis layouts without fuss.

Specifications

  • Scale: 1/10
  • Brushless: Yes
  • Sensored: Yes
  • KV Rating: 5750
  • Suitable LiPo Cells: 2S
  • No-load Current (A): 4.6
  • Dimensions: 36mm (O.D.) x 52.8mm (Length)
  • Shaft Diameter: 3.17mm
  • Weight: 194g
  • Timing: Fixed

A practical choice for tuners and weekend racers, the 30404312 sensored motor pairs usable low-speed control with straightforward installation for many 1/10 builds.

Yes. The smooth throttle response from the sensored design makes it well suited to controlled slides and low-speed drift work.
Its 36mm by 52.8mm package fits the majority of 1/10 and many 1/12 chassis, but check clearance for motor mounts and pinion spacing on compact kits.
Use an ESC rated for sensored brushless motors and support 2S LiPo. Ensure the ESC firmware and sensor wiring are configured for sensored operation for best start-up behavior.
Spin the motor by hand and listen for roughness, then remove the endbell to inspect for play or grit. Replace bearings if you detect noise or binding.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved