Hot Bodies Cyclone Pivot Mount Shims CY-34 0.5/1mm Set for Fine Tuning by 3Racing  [CY-34]

Precision graphite shims for Cyclone

This CY-34 graphite shim set is designed to give modelers accurate spacing at the pivot and mount interface on compatible Cyclone variants. With 0.5mm and 1mm options you can micro-adjust pivot alignment and clearance to improve balance across a variety of surfaces.

Installation is straightforward: remove the mount fasteners, insert the chosen shim between the mounting faces, and reassemble while observing correct screw torque. Keep the contact areas free from grease and grit and avoid excessive tightening that could compress the shim material.

Setup notes: the thinner 0.5mm shim is suited to subtle clearance fixes or to reduce binding, while the 1mm shim is useful when a bigger offset is needed to alter roll center or toe-in slightly. These shims are a lightweight, low-cost way to iterate on setup between runs.

Model fitment

• Hot Bodies Cyclone Sport Version
• Hot Bodies Cyclone Racing Version