3Racing LA-11/PU Purple Front Gearbox for Hot Bodies MiniZilla Performance Pack  [LA-11/PU]

Hot Bodies MiniZilla Chassis Aluminium Front Gear Box For Hot Bodies Minizilla - Purple Color - 3Racing LA-11/PU
Price:
NZD$30.76
Brand:
3Racing
Model:
LA-11/PU
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Hot Bodies - MiniZilla category
Write a review

Fit a Strong Aluminium Front Gearbox to Your MiniZilla

The Hot Bodies MiniZilla chassis gains increased resilience from the 3Racing LA-11/PU aluminium front gearbox. Purpose-built for the MiniZilla, this unit replaces weaker stock parts to give better rigidity and repeatable gear alignment. The purple anodised surface defends against everyday wear while adding a custom look.

Why an Aluminium Unit Helps Handling

Aluminium housings reduce flex under acceleration and braking, which keeps pinion and spur alignment more consistent. The result is crisper throttle response and reduced drivetrain lash, useful for drivers tuning handling balance.

Simple Fitment and Compatibility Tips

This 3Racing LA-11/PU gearbox is produced to match Hot Bodies MiniZilla mounting points for a straightforward swap. During installation, verify mesh and fastener torque to prevent noise and premature part wear.

Can I run this with standard MiniZilla electronics?

Yes, the gearbox does not affect electronic fitment. Make sure servo and motor clearances are checked when installing to avoid contact with the new housing.

Does the anodised finish need special care?

Routine cleaning with a soft brush and mild detergent is sufficient. Avoid harsh solvents that may dull the anodising over time.

Will this change the car weight significantly?

Aluminium is slightly heavier than plastic in some areas, but the stiffness-to-weight tradeoff usually benefits handling. Expect a small increase in mass concentrated at the front end.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved