HPI Baja Compatible Rear Rim Frame Nylon with Alloy 10-Poles Pattern BJ1003R by GPM  [BJ1003R]

Baja rear rim frame - compatible with HPI Baja

This replacement rear rim frame is an aftermarket accessory for HPI Baja platforms that centres on wheel strength and alignment rather than styling. It combines an impact-resistant nylon body with an alloy 10-poles patterned insert to support spoke positioning and improve load sharing during off-road running.

Compatibility is based on the rim mounting pattern stated in the product name and is suitable for HPI Baja variants that use the same rear rim interface. Check wheel hex dimensions, hub fit and tyre seating to confirm compatibility before installation.

Installation guidance: take the wheel off as a single assembly, inspect the six-sided wheel hex and hub for wear, move bearings and any spacer rings into the new rim frame, tighten bolts evenly and perform a roll check to ensure minimal runout.

For hobbyists replacing rear rim frames on HPI Baja cars, the GPM BJ1003R is built for dependable structure and consistent wheel alignment; confirm hub and bearing condition during the swap to maintain handling balance.