HPI Baja Front Rim Frame Nylon Body with Alloy Ten-Pole Face BJ1003F by GPM  [BJ1003F]

HPI Baja Nylon Front Rims Frame With Alloy 10 Poles Pattern - GPM BJ1003F
Price:
NZD$130.70
Brand:
GPM
Model:
BJ1003F
GTIN:
4894538025002
Condition:
Brand New
Write a review
alt="HPI Baja Nylon Front Rims Frame With Alloy 10 Poles Pattern - GPM BJ1003F" title="HPI Baja Nylon Front Rims Frame With Alloy 10 Poles Pattern - GPM BJ1003F"
alt="HPI Baja Nylon Front Rims Frame With Alloy 10 Poles Pattern - GPM BJ1003F" title="HPI Baja Nylon Front Rims Frame With Alloy 10 Poles Pattern - GPM BJ1003F"
alt="HPI Baja Nylon Front Rims Frame With Alloy 10 Poles Pattern - GPM BJ1003F" title="HPI Baja Nylon Front Rims Frame With Alloy 10 Poles Pattern - GPM BJ1003F"

Front rim upgrade for HPI Baja

This aftermarket front rim frame fits HPI Baja buggies and is listed as model BJ1003F. The design combines a molded nylon carrier for structural support with an alloy ten-pole patterned face that adds stiffness and a scale-correct look to the wheel.

Intended as a direct replacement or an upgrade, the component is focused on predictable performance under rough off-road use and reliable wheel mounting. Confirm your Baja wheel hub, hex size, and wheel offset to ensure the rim frame will seat correctly.

Fitting is simple for hobbyists experienced with wheel service: remove the wheel, position the rim frame over the hub, and tighten using the original wheel fasteners. Note that the nylon carrier will flex more than an all-metal wheel and can help with impact absorption, while the alloy face concentrates mass near the rim edge.

Specifications

  • Item: Front Rims Frame
  • Material: Nylon and Alloy
  • Model Number: BJ1003F
  • Compatibility: HPI Baja

Fit model BJ1003F when you want a front rim that balances nylon flexibility with an alloy-pattern face for HPI Baja wheel packages.

Is this compatible with all Baja wheel hubs?

The rim frame is designed for Baja platforms but compatibility depends on your specific hub hex and offset; measure before ordering to avoid mismatch.

Can I reuse my existing wheel hardware?

Yes, reuse original wheel fasteners where they match the rim frame, and keep track of any washers or spacers during installation for correct alignment.

What maintenance does the rim need?

Regularly clean mud and sand, check mounting holes and the carrier for hairline cracks, and replace if deformation affects wheel balance or seating.

Will this affect wheel balance?

The alloy face can shift mass distribution slightly toward the rim edge versus a plain nylon rim, which may require a quick balance check if you notice vibration at speed.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved