HPI Bullet 3.0 Compatible Adjustable Tie Rods Front & Rear BMT160A/ST by GPM  [BMT160A/ST]

Steering link upgrade for Bullet 3.0

This adjustable front and rear tie rod set fits HPI Bullet 3.0 MT and ST chassis using model BMT160A/ST. It combines spring steel rod bodies with alloy end fittings and 4mm anti cross-thread connections, supplied as a 6 piece set to replace original links on both axles.

Length adjustment lets you alter toe and steering geometry with two extendable ranges: 73-80mm and 78-85mm. The threaded alloy ends provide secure adjustment and help prevent cross-threading on the 4mm connections.

Installation involves swapping out the factory tie rods, attaching the alloy ends to steering knuckles and hub carriers, then fine-tuning each link to set toe. Verify suspension travel and full-lock steering to ensure no binding after setup.

These links are intended as a serviceable tuning accessory to refine handling and replace worn linkages; they are not a change to servos, ESCs, motors, or gearboxes.

Use these adjustable tie rods for reliable steering linkage and to dial in toe settings on HPI Bullet 3.0 MT and ST models when replacing aged or bent links.