HPI Bullet 3.0 MT and ST Rear Alloy Beadlock Wheels with Nylon Frames BMT0503R+889 by GPM  [BMT0503R+889]

Beadlock rear wheel upgrade kit

This aftermarket assembly replaces the rear wheels on HPI Bullet 3.0 MT and ST nitro vehicles with rubber tyres mounted to nylon rim frames, alloy 5-star beadlock rings and included 12x9mm drive adapters. The kit is designed to provide a serviceable beadlock solution without modifying axle or hub geometry.

Fitment follows typical rear wheel procedures for nitro trucks: open the beadlock, mount the rubber tyre onto the nylon frame, position the alloy 5-star ring and tighten the screws. The supplied 12x9mm adapters are intended to mate with the common rear axle stub used on HPI Bullet 3.0 MT and ST nitro variants for a direct interface.

Using these wheels allows independent changes to rim rigidity and tyre choice, which can be useful when tuning handling or unsprung weight. Choose this set when you want a straightforward replacement that keeps factory axle alignment intact while adding durable beadlocks.

This GPM wheel and tyre set is a practical direct-fit aftermarket replacement for HPI Bullet 3.0 MT/ST nitro models, ideal for hobbyists seeking beadlock serviceability and matched adapters without drivetrain trimming.